Gardner Denver 5 HP BR5 base mount industrial electric air compressor. This machine produces 17.3CFM @ 175PSI.
COMPRESSOR PUMP WARRANTY
Each new Gardner Denver Assembled Unit has a five (5) year warranty on the compressor pump only, against defects in materials or workmanship under normal use and service, from the date of installation or sixty-six (66) months from the date of shipment by Gardner Denver or a Gardner Denver distributor, whichever may occur first.
The five-year extended warranty covers parts and labor and is prorated over the five years as follows:
Year One ¡ª 100% coverage
Year Two ¡ª 90% coverage
Year Three ¡ª 80% coverage
Year Four ¡ª 70% coverage
Year Five ¡ª 60% coverage
Head valves are warranted for Year One only. Gardner Denver makes no warranty on components and/or accessories furnished to Gardner Denver by third parties, such as electric motors, gasoline engines and controls. These are warranted only to the extent of the original manufacturer ¡¯s warranty to Gardner Denver. Electric motors must be equipped with thermal overload protection to have warranty consideration. The extended five-year warranty will apply to ASME air receivers if they are installed on rubber vibro isolator pads or approved equivalent.
5 YEAR ELECTRIC MOTOR
Any Gardner Denver package purchased after January 1, 2003 built with a Baldor or Toshiba electric motor are warranted for 60 months from start-up or 63 months from shipment. Other manufacturer¡¯s motors furnished due to customer request or special requirements carry the motor manufacturer ¡¯s warranty.
PACKAGE WARRANTY
Gardner Denver warrants each new air compressor package to be free from defects in material and workmanship under normal use and service for a period of one year (12 months) from the date of installation or 15 months from the date of shipment by Gardner Denver. Units manufactured in Canada have a pump and package warranty for two (24 months) years.
LIMITED WARRANTY
Warranty shall not apply to any equipment which has been subjected to misuse, neglect or accident, nor shall it apply to any equipment that has been repaired or altered by any person(s) not authorized by Gardner Denver. Failure caused by lack of proper maintenance is not covered by warranty.
In no event shall Gardner Denver be liable for consequential damages or contingent liabilities arising out of failure of any compressor or part to operate properly. When a compressor pump or component is changed or replaced during the warranty period, the new/replaced item(s) is warranted for only
the remainder of the original warranty period. Complete warranty details are included in compressor operating manual.
U.L. STANDARDS
Gardner Denver, in common with other major, industrial compressor manufacturers, does not market compressors which are U.L. listed. In general, U.L. is concerned with electrical components that may be utilized on compressor units, rather than a complete compressor package or system. All electrical components used on Gardner Denver compressors are U.L. listed. Each component ¨C motor, starter, pressure switch, control panel ¨C carries a U.L. identification mark on the nameplate or inside the electrical enclosure cover. The mark will be the letters ¡°UR ¡± reversed (as if held up to a mirror),
indicating the item is ¡°recognized¡± by U.L. On tankmounted units, the air receiver tank and tank pressure relief valve are ASME Code. The tank carries a National Board Registration number which appears on a stamped, metal plate welded to the tank.
|
